Micro Engineering Solutions, Inc.
Micro Engineering Solutions, Inc. was a CAD/CAM (Computer Aided Design / Computer Aided Manufacturing) software company founded in 1986 by Lynn and Jim Hock and Bill Harris in Farmington, Michigan. The initial product was "Solution 3000", a PC based CAD/CAM system that ran on a standard IBM PC "AT" (or clone), running under IBM PC DOS, with 640kb of memory. Additional required hardware included a math coprocessor, a 20MB hard disk drive with floppy disk backup, a graphics display interface, and a graphics monitor. In 1991, the Board appointed Ken Spenser as President and CEO.
primaryTopic
Micro Engineering Solutions, Inc.
Micro Engineering Solutions, Inc. was a CAD/CAM (Computer Aided Design / Computer Aided Manufacturing) software company founded in 1986 by Lynn and Jim Hock and Bill Harris in Farmington, Michigan. The initial product was "Solution 3000", a PC based CAD/CAM system that ran on a standard IBM PC "AT" (or clone), running under IBM PC DOS, with 640kb of memory. Additional required hardware included a math coprocessor, a 20MB hard disk drive with floppy disk backup, a graphics display interface, and a graphics monitor. In 1991, the Board appointed Ken Spenser as President and CEO.
has abstract
Micro Engineering Solutions, I ...... d Micro Engineering Solutions.
@en
Wikipage page ID
46,686,335
Wikipage revision ID
706,239,556
comment
Micro Engineering Solutions, I ...... Spenser as President and CEO.
@en
label
Micro Engineering Solutions, Inc.
@en