Data strobe encoding
Data strobe encoding (or D/S encoding) is an encoding scheme for transmitting data in digital circuits.It uses two signal lines (e.g. wires in a cable or traces on a printed circuit board), Data and Strobe. These have the property that either Data or Strobe changes its logical value in one clock cycle, but never both. More precisely data is transmitted as-is and strobe changes its state if and only if data stays constant between two data bits.This allows for easy clock recovery with a good jitter tolerance by XORing the two signal line values.
Wikipage redirect
Link from a Wikipage to another Wikipage
primaryTopic
Data strobe encoding
Data strobe encoding (or D/S encoding) is an encoding scheme for transmitting data in digital circuits.It uses two signal lines (e.g. wires in a cable or traces on a printed circuit board), Data and Strobe. These have the property that either Data or Strobe changes its logical value in one clock cycle, but never both. More precisely data is transmitted as-is and strobe changes its state if and only if data stays constant between two data bits.This allows for easy clock recovery with a good jitter tolerance by XORing the two signal line values.
has abstract
Data strobe encoding (or D/S e ...... alue, but never more than one.
@en
Wikipage page ID
page length (characters) of wiki page
Wikipage revision ID
997,890,151
Link from a Wikipage to another Wikipage
wikiPageUsesTemplate
subject
hypernym
type
comment
Data strobe encoding (or D/S e ...... ng the two signal line values.
@en
label
Data strobe encoding
@en